Envoy NT9010A Instalační příručka stáhnout pdf (Strana 48)

Chapter 2: Advanced Programming

There is no ringback when using Pager Format. The system has no way of confirm-

ing if the pager was called successfully. A failure to communicate trouble will only

be generated once the maximum number of attempts has been reached.

NOTE: Do not use the digit C in a reporting code when using Pager Format.

In most cases, the digit C will be interpreted as a [#], which will terminate

the page before it has finished.

NOTE: If the system detects a busy signal, it will attempt to page again. It

will make the maximum number of attempts programmed in section [160].

NOTE:Force dialing should be disabled when using Pager format.

NOTE: When using Pager format, you must program two pauses (hex digit

E) at the end of the telephone number.

Communicator Format Options . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Section [360]

2.3.12

Communicator

Reporting

Codes

Unless you are using Automatic Contact ID or Automatic SIA formats, reporting codes

must be programmed in order for the system to report events to the central station.

Reporting codes are two digits and can use hexadecimal digits A through F. To disable

a reporting code, program it as “FF” (default setting) or “00”. For a complete descrip-

tion of reporting codes which can be programmed and lists of automatic Contact ID

and SIA format codes, please see Appendix B: Reporting Codes on page 54.

Transmission Delay

The Transmission Delay feature is used to delay reporting of alarms. When a zone is

violated and causes an alarm, the Transmission Delay Timer will start. When the

timer expires, the system will transmit the programmed reporting code. If the sys-

tem is disarmed before the timer expires, the alarm will not be transmitted.

The Transmission Delay zone attribute determines which zones will start the timer.

Transmission Delay Zone Attributes . . . . . . . . . . Sections [101] to [132], Option [7]

Transmission Delay Timer. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Section [370]

Low Battery Transmission Delay

When using wireless devices, the battery status of the devices will be monitored by

the system. If a low battery condition exists, the system will indicate a general

transmitter low battery trouble. The system will delay reporting the event for the

number of days programmed as the Low Battery Transmission Delay. This delay

provides the user with an opportunity to change the batteries on the units before

the condition is reported to the central station. Instruct the customer on how to

change the batteries of wireless devices to gain maximum use of this feature.

NOTE: After the first Wireless Device Low Battery reporting code is sent,

the system will not send additional low battery events until the first low

battery trouble is restored.

Low Battery Transmission Delay . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Section [370]

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 63 64

Žádné komentáře

Envoy NT9010A Instalační příručka Strana 48