Envoy NT9010A Instalační příručka stáhnout pdf (Strana 13)

Section 1.2: Installing The NT9010

If there is a Remote Sounder on the system and it does not report a supervisory sig-

nal within 30 seconds, a “Service Required” trouble will be generated, and a

“Remote Sounder Trouble” event will be logged in the buffer.

See also 2.3.13 Talk/Listen-in Programming on page 46.

Local Annunciation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Section [017], Option [4]

Remote Annunciation . . . . . . . . . . . . . . . . . . . . . . . . . . . Section [017], Option [5]

Attach NT9010 to Backplate

NOTE:Before attaching the backplate, be sure to

connect the battery. See 1.2.5 Connecting the Bat-

tery on page 6.

When you have mounted the backplate to the wall,

completed the wiring, and connected the battery, you

can attach the NT9010 unit to the backplate.

1. Push the bottom of the NT9010 onto the backplate

posts, as shown at right.

2. Snap the top of the NT9010 onto the top of the

backplate, as shown at right.

3. Secure the NT9010 to the backplate by replacing

the plastic screw in the top of the NT9010.

1.2.6 Mounting the

Wireless

Devices

Do not permanently mount the wireless devices until you have completed the

Placement Tests (see 1.2.7 Enrolling Devices and Setting Up the System on

page 9). Once you have a good location for each of the devices, follow the mount-

ing instructions on the Installation Instruction sheet for each device. For WLS904P-

433, see Appendix E: WLS904P Wireless Motion Detector Installation

Instructions on page 58. For WLS925L-433, see Appendix D: WLS925L-433

Mini Door/Window Contact Installation Instructions on page 57.

1.2.7 Enrolling

Devices and

Setting Up

the System

Flash Programming will guide you through the steps needed to set up each zone and

basic system programming. If you need to perform more advanced programming for

your installation, please see Chapter 2: Advanced Programming on page 15.

To access Flash Programming:

1. Press [✱][8].

2. Enter the Installer’s code. The Installer Code is [5555] at default, but should be

changed to prevent unauthorized access to programming.

3. Press [1] to enter Flash Programming.

4. Follow the audio instructions announced by Flash Programming. Flash Program-

ming will guide you through the following programming areas:

■ Device enrollment

■ Zone label assignment

■ Central station telephone number

■ System account code

■ Placement tests of each wireless device

WALL

1. Push bottom

of NT9010 onto

backplate posts

2. Snap top of

NT9010 onto

top of backplate

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 63 64

Komentáře k této Příručce

Žádné komentáře

Envoy NT9010A Instalační příručka Strana 13

Komentáře k této Příručce